Protective gloves for polymechanic / cnc operator
Work with non-water-based solvents, diluters or cleaners
Gloves resistant to chemical products, manufactured from a variety of materials. The manufacturers usually provide supplementary information on the resistance of the gloves to different chemical products.
Work with 2-component resins, paint, varnish and adhesives (protection against accidental contact)
Gloves in pure nitrile. They must be replaced when they have been contaminated by the product being handled. The material of the gloves can be permeated by chemicals after a short period of contact, or it can tear.
Soldering and welding (normal requirements, MIG, MAG)
Gloves in leather or gloves in textile and leather
Precision manual work with greasy objects
Textile gloves whose partial coating gives a degree of protection against permanent contact with oil and grease. The correct size is very important for a high level of dexterity.
Work with CNC machines and towers
Single-use gloves in nitrile to prevent contact with refrigerating lubricants
Warning notice: It is essential to check the resistance of the gloves to specific chemicals by referring to resistance tables
Herein below we give a few guidelines for the use of gloves although we take no responsibility for these recommendations. These guidelines do not replace the analyses of physical and chemical risks at each workplace including proper evaluationof technical specifications supplied by distributors and manufacturers.